Noise Reduction

GoldWave general discussions and community help
Post Reply
Frink
Posts: 2
Joined: Wed Jan 29, 2014 8:54 am

Noise Reduction

Post by Frink » Wed Jan 29, 2014 9:04 am

Hi All,

I'm thinking of changing from Sound Forge to Goldwave (cost reasons mainly) but there is one function in Sound Forge that I can't do without: Noise Reduction.

Specifically, I'm using this function to capture a noiseprint and then remove the print signature from the whole audio clip.

i.e.
I place an audio file into Sound Forge, take a sample of a small clip of the wave BEFORE singing takes place (in other words, a clip of 'silence' which might include some background hum or hiss.
I then take a noiseprint of this section and then remove it from the whole clip.

This is much better than simply gating the low noise at the point of recording as this only removes the hum or hiss from the quiet portions of the vocal take.

Is the Noise Reduction function in Goldwave capable of this operation?

Many thanks for your help!

Frink.

Gord
Posts: 391
Joined: Thu May 21, 2009 4:26 pm
Location: Canada

Re: Noise Reduction

Post by Gord » Wed Jan 29, 2014 10:36 am

Yes, GoldWave can do that. From the Help file:
Noise Reduction
===============

...

A reduction envelope is used to remove noise. The envelope can be created in four different ways, depending on the Reduction envelope setting as explained below. The Use clipboard option often gives the best results.

...

Use clipboard
-------------

Analyzes the audio in the clipboard and creates an envelope based on it. To use this setting, you must first copy part of the sound where the noise exists by itself. Like the Use current spectrum setting, this can remove a buzz, hum, static, and other common noises. The clipboard noise can be based on audio copied from another file or audio outside the current selection. In general, this is the best setting to use.

Tristan
Posts: 324
Joined: Mon Jun 01, 2009 8:20 pm
Location: Southeast Michigan

Re: Noise Reduction

Post by Tristan » Wed Jan 29, 2014 12:06 pm

What Gord said.
If I can read the manual, so can you.

donrandall
Posts: 540
Joined: Wed Dec 01, 2004 11:06 pm
Location: Denver, Colorado

Re: Noise Reduction

Post by donrandall » Sun Feb 02, 2014 6:29 pm

Two or three years ago, I had the opportunity to try Sound Forge. It may be a lot better now, but at the time it was no where close to Goldwave. The Noise Reduction tool in Goldwave is really very, very good.

Someone I "know" from a different message board had a voice track that needed some help... there was some slight extraneous noise from an air conditioning compressor just outside her apartment and she could not get it cleaned up using another (more expensive) recording software program. I had her send me a .wav copy of her file so I could see if Goldwave could do what another "Big Name" application could not. I could find only a very tiny sample of the offending "whir" of the compressor noise... less than a quarter of a second was all I could get.

I used Goldwave's Noise Reduction tool and made the offending noise go away, without any of the odd artifacts that often remind people of Star Wars sound effects.

I believe you can still download and use and evaluate Goldwave without any cost, so why not do it? I think you will be pleased.

Post Reply