Hi
I have a need to remove a rising high tone from a recording of a locomotive working.
Basically its the turbo noise I want to remove.
How can I do this in Goldwave please?
How to remove a rising tone from audio
-
- Posts: 5
- Joined: Wed Mar 20, 2013 5:58 am
- Location: Sussex UK
- Contact:
Re: How to remove a rising tone from audio
What's the frequency range of this rising tone?
I don't want to read the manual either, but, then, it isn't my problem, is it?
-
- Site Admin
- Posts: 4372
- Joined: Wed Mar 10, 2004 6:43 pm
- Location: St. John's, NL
- Contact:
Re: How to remove a rising tone from audio
You may be able to use the Bandpass/Stop filter. It allows you to set a frequency range to block (stop) that changes over time.
-
- Posts: 5
- Joined: Wed Mar 20, 2013 5:58 am
- Location: Sussex UK
- Contact:
Re: How to remove a rising tone from audio
Thanks guys, this site was down for me so I am only just reading.
I'll measure the tone I need to remove and report back, thanks
I'll measure the tone I need to remove and report back, thanks