Page 1 of 1

Capture Properties

Posted: Wed Aug 25, 2010 1:36 pm
by harshbaj
I am trying to capture from my tv tuner. How do I setup the properties to do so. It recognizes my tuner but will not show any channels. I did the autotune, but to no avail.


Re: Capture Properties

Posted: Thu Aug 26, 2010 12:55 pm
by GoldWave Inc.
Normally you'd display the Video Capture window, then click on the Properties button. What you see on that window depends on the device. You may see several tabs that allow you to adjust various settings. The channel settings should be there. If not, try changing the device using the Device button (if more than one is available), then choose the Properties button again to see what's there.

There is a channel up/down control on the Video Capture window as well. It's enabled if the device supports channel changes.