How to use AUTOFADE to cut off music?

General discussions and questions about MULTIQUENCE
Post Reply
seostudy2004
Posts: 9
Joined: Thu Nov 04, 2004 6:56 pm

How to use AUTOFADE to cut off music?

Post by seostudy2004 »

Chris,

I've been working hard to make "autofade" happen for the music track on my video, but still could not figure out how to use it. Basically I want to end the background music when the video ends, but my music file is too long. I can cut it by "TRIM END" but I want it to end with autofade.

I did have tried to add "autofade" on the "EFFECT." But the problem is: I could not add this feature on the music track (say track 2). I was asked to create a new track and put autofade on that, so it could not work. In addition, I could not tell the difference of different "preset" autofade such as "cross fade," "instant 50" and "one second blend."

Would you please highlight the procedure? I realize you are busy, but please throw some lights in so that I can get through this last barrier for a good video editing experience. Thank you so much!

GoldWave Inc.
Site Admin
Posts: 4019
Joined: Wed Mar 10, 2004 6:43 pm
Location: St. John's, NL
Contact:

Re: How to use AUTOFADE to cut off music?

Post by GoldWave Inc. »

Autofade is designed for voice over work where you need to fade the background audio when many voice sections are present.

To fade out the end of a song, you'll need to use the Effect | Fade graph command to display the fade line in sections, then click on the line or drag the points to change the shape so it slopes downward for the last 5 seconds or so.

See the "Discovery Launch" section in the third track on the screen shot for an example of a section with both fade in and fade out.

Chris

Post Reply