Capture Properties

General discussions and questions about MULTIQUENCE
Post Reply
harshbaj
Posts: 1
Joined: Wed Aug 25, 2010 1:26 pm

Capture Properties

Post by harshbaj » Wed Aug 25, 2010 1:36 pm

I am trying to capture from my tv tuner. How do I setup the properties to do so. It recognizes my tuner but will not show any channels. I did the autotune, but to no avail.

Help.

GoldWave Inc.
Site Admin
Posts: 3897
Joined: Wed Mar 10, 2004 6:43 pm
Location: St. John's, NL
Contact:

Re: Capture Properties

Post by GoldWave Inc. » Thu Aug 26, 2010 12:55 pm

Normally you'd display the Video Capture window, then click on the Properties button. What you see on that window depends on the device. You may see several tabs that allow you to adjust various settings. The channel settings should be there. If not, try changing the device using the Device button (if more than one is available), then choose the Properties button again to see what's there.

There is a channel up/down control on the Video Capture window as well. It's enabled if the device supports channel changes.

Chris

Post Reply